Great Gyro some shops asks more R550 for same Gyro.
Use a digital servo,
Set your speed first,
Set Directions and
Set Travel.
And VOILA!!!
Solid as a rock. Use it on my 250, 450 and 500.

From: greeffbf | Created on: 12/30/2011 5:16 PM

My first reaction was too cheap to trust.
I descided to get one in any case just to try.
I first had it on my HK450 and then tested it on my HK600 chopper. What I found is this.

The gyro has no buttons for programming and you get it to go into programming mode by following quite a complicated procedure via your Transmitter. Once you are in programming mode, though, it is a breeze to set up. It has some nice features you can program.

In flight, it is rock solid. Even with low rotor speed it holds the tail steady and WITH NO DRIFT. Even if you fly your chopper at full speed sideways, the tais stays dead steady. I am no a 3D pilot, so could not test it so, but during stall turns and reverse flight, it had no hassles.

Only thin to remmeber with this gyro is ONLY use fully digital servos like the DS480 and BLS980 servos with his gyro. It will fry any analog servos.

I say Chuck the 401 gyro and get one of these.

From: loodbirk@pages4africa.co.za | Created on: 5/12/2011 9:50 PM

This little monster will change the way you think about Gyro's forever!

Fully programmable, comes with detailed instructions.

I have been flying the GA 250 on both my 450 and 500 HK's, and the tails are rock solid!

Other less expensive gyro's tend to start losing the tail at low voltage toward the end of the flight, this is not the case with the GA 250.

Use the thinner double sided tape on electric helis, and use the default setting for servo selection if your servo is not listed in the diagram supplied, choosing the wrong servo could damage your gyro, so be very carefull!

All in all agreat gyro at a great price, make sure to order more than one!

From: frankenhand | Created on: 5/12/2011 6:39 PM